SCAMP Progress

October 15th, 2015

I just glued up the transom.  Now for some work on seat and sole cleats.

Joe_scamp1015

PT11 Floats!

July 21st, 2014

Here’s Petey under sail in the Bahamas.

PT11_bahamas_lg

PT11 with Rudder

December 19th, 2012

I’m getting close.  I need to glue on the rubber gunwale bumpers and then Petey is ready to sail to Florida.

PT11 Reorg

October 1st, 2012

The shop got too crowded with 2 boats in process, so the SCAMP got archived for now,  and the mobile platform re-purposed for the PT11 build.   The bulkheads on the bench got glued into the hull yesterday.

PT11

September 14th, 2012

I’m building a PT11 Nesting Dinghy kit from Port Townsend Watercraft for a client.   Here’s the stitched up hull.   The gunwales get attached tomorrow.

 

SCAMP Assembly

August 11th, 2012

I’ve coated the planks, aft bulkheads, and boat bottom.  I need to fiberglass the centerboard case next and then start assembling the boat.

SCAMP

July 17th, 2012

I’m building a small sailboat designed by John Welsford.  It’s called SCAMP and is a project created by Small Craft Advisor magazine.  I’m finishing up the building jig at the moment.

Yellowstone – Lamar Valley

September 29th, 2011

I’m back in Yellowstone Park.  Everything should be shutdown by now but the weather is glorious. Here’s some fall color along the Lamar River in the north edge of the park.

Oregon Trail – Lander-cutoff, WY

September 28th, 2011

I was heading through northwest Wyoming on my way to the Tetons today when I ran across a section of the Oregon Trail. This is the Lander-cutoff which saved about 5 day on the trail. You can still see the wagon ruts.

Fiery Furnace

September 26th, 2011

This is a view of Fiery Furnace in Arches National Park.